Vimar Eikon 20461 - Page 93

ENGLISH - 35
6.7.9
Insert into the reader a MASTER smart
card programmed by that same reader,
to enable continuation of the procedure.
Synchronising an already-initialised reader
6.7.8
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED turns green and the system switches to the
“Change reader and MASTER smart card codes”
procedure.
To exit the procedure, place dip-switch 2 in the
OFF position.
Repeat the procedure from step 6.7.7.
6.7.6
To exit the procedure, place dip-switch 2
in the OFF position
If dip-switch 1 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 2 in the OFF
position.
6.7.7
Place dip-switch 2, on the reader being
synchronised, in the ON position.
The LED lights up yellow.
1 2 3 4
6
7 8
ON
1 2 3 4
6
7 8
ON
off
yellow
Card
already
programmed
Card
already
programmed
green
green