34 - ENGLISH
6.7.2
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED turns green and the system switches to the
“Initialise reader and program MASTER smart
cards” procedure.
To exit the procedure, place dip-switch 2 in the
OFF position.
Repeat the procedure from step 6.7.1.
6.7.3
Insert a MASTER smart card, already pro-
grammed by the synchronising reader/
programmer, into the reader being syn-
chronised.
6.7.4
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
The device awaits the synchronising smart card
for about 2 minutes, after which the LED turns
yellow and no further commands are accepted.
To resume normal operation, place dip-switch 2
in the OFF position.
6.7.5
Remove the smart card.
The LED turns green again.
Synchronising
card
Synchronising
card
green
green
2 minutes
yellow
off
green
To Next Page
Loading...