Vimar Eikon 20461 - Page 84

26 - ENGLISH
6.3.6
Insert the SLAVE smart card to be pro-
grammed.
The device waits for a SLAVE smart card to pro-
gram for about 2 minutes, after which it auto-
matically exits the procedure.
Exiting is signalled by the LED blinking yellow 3
times.
6.3.5
Remove the MASTER smart card.
The LED turns green again, waiting for a
SLAVE smart card to program.
6.3.7
When the LED turns off, the dupli-
cate SLAVE smart card has been pro-
grammed.
6.3.9
To exit the procedure, press the front but-
ton. The LED will blink yellow 3 times, and
then turn off.
If no smart cards are inserted for about 2 min-
utes, the procedure automatically terminates.
Exiting is signalled by the LED blinking yellow 3
times.
The device waits for a SLAVE smart card to
program for about 2 minutes, after which it au-
tomatically exits the procedure.
Exiting is signalled by the LED blinking yellow 3
times.
6.3.8
Remove the SLAVE smart card.
The LED turns green again, ready to pro-
gram other SLAVE smart cards.
To program additional SLAVE smart
cards, repeat the procedure from
step6.3.6.
MASTER
card
MASTER
card
SLAVE
card
SLAVE
card
2 minutes
green
yellow
green
off
green
yellow