46 - ENGLISH
7.2.9
To exit the procedure, press the front but-
ton.
The LED blinks yellow 3 times, and then
turns off.
7.2.7
When the LED turns off, the SLAVE smart
card has been programmed.
7.2.8
Remove the SLAVE smart card.
The LED turns green again, waiting for
other SLAVE smart cards to program.
To program additional SLAVE smart
cards, repeat the procedure from step
7.2.6.
If no smart cards are inserted for about 2 min-
utes, the procedure automatically terminates.
Exiting the procedure is signalled by the LED
blinking yellow 3 times.
off
green
2 minutes
yellow
yellow
To Next Page
Loading...