22 - ENGLISH
6.1.5
When the LED turns green (after about 10
seconds), insert the smart card to be pro-
grammed as the MASTER.
6.1.7
Remove the smart card.
The LED turns green again, waiting for
other smart cards to program.
To duplicate additional smart cards, re-
peat the procedure from step 6.1.5.
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, replace dip-switch
2 in the OFF position.
6.1.8
To exit the procedure, place dip-switch 2
in the OFF position.
6.1.6
When the LED turns off, the MASTER
smart card has been programmed.
The device waits for the smart card for about 2
minutes, after which the LED turns yellow and
no further commands are accepted. To resume
normal operation place dip-switch 2 in the OFF
position.
2 minutes
green
yellow
off
1 2 3 4
ON
green
off
To Next Page
Loading...