Operators Manual
Operation
M55-ML3-UG, Rev A
32
3. Once the Apply button is clicked, the chosen setting turns Green as shown in the
figure below.
8.3.6. Advanced Settings
The Advanced setting page enables the configuration of three parameters
• User Data
• Telemetry Channel
• Encryption
8.3.6.1. Baud Rate
Choose User data baud rate vis drop-down menu.
8.3.6.2. Telemetry
Choose telemetry channel to match Focal Point Camera/Remote Control – Channels 1-5
8.3.6.3. Encryption (Optional)
Click the menu button to choose the Settings page, and then navigate to the Encryption
section via the Advanced tab. Use the Encryption drop-down menu to choose the needed
settings. The options are:
• Disabled
• Key 1
• Key 2
• Key 3
• Key 4
• Key 5
Click Apply; a “setting saved” banner appears when changes have been saved.
8.3.7. Frequency Plan Page
Ten channels may be programmed into the Microlite 3. Current frequencies have the
option of editing or deleting, based on its usage for an application. The frequencies are in
MHz.
Click the Menu selection button to navigate to the Frequency Plans page.
To Next Page
Loading...
General