OPERATING THE POWERMASTER SYSTEM
D-307502 PowerMaster-10/30 G2 User's Guide 11
PRESENT TAG OR
ENTER CODE _ _ _ _
[Enter Code] /
[Present tag]
ARM indicator extinguishes during the disarmed state. Disarming the system also stops the siren alarm,
irrespective of whether the alarm was initiated during the armed or the disarmed state.
Disarming under Duress
If you are forcibly compelled to disarm the system, enter the duress code (2580 by default) or another code set
by the installer. Disarming will take place normally but a silent alarm will be transmitted to the monitoring station.
Partition Selection Process
Access to any desired partition is achieved through the use of an individual code or proximity tag. It is not
possible to access the INSTALLER MENU if one or more partitions are in the AWAY or HOME modes.
Before attempting to perform any operation on any given partition(s), it is necessary to perform the operations
below which enable you to select the desired/allowed partition(s) using the individual code or proximity tag:
Enter partition # (1 - 3)
Note: The “Failure Tune” will be heard when selecting a partition to which no sensors / peripherals were
enrolled.
Special Arming & Disarming Options
In addition to basic arming, PowerMaster provides you with several advanced arming and disarming options:
Switching from ‘HOME’ to ‘AWAY’
You do not have to disarm the system - just press
. The response will be the same as in ARMING
AWAY above. Vacate the premises before the exit delay expires.
Switching from ‘AWAY’ to ‘HOME’
You do not have to disarm the system - just press
.
Since this operation reduces the security level, Power-
Master will ask you to key in your master user code or user code, thus making sure that you are an authorized user.
PRESENT TAG OR
ENTER CODE _ _ _ _
[Enter code] /
[Present tag]
ARM indicator flashes during the armed state.
Arming AWAY or HOME ‘Instant’
Pressing during the exit delay will arm the system in the "Instant' mode, i.e. without an entry delay.
Therefore, any detection in any zone will trigger an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
To Next Page
Loading...
Need help?
General