Visonic PM-10 TRIPLE User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
D-307502 PowerMaster-10/30 G2 User's Guide 43
Event Group Option
Events to be reported
disable report
No message will be reported
all
All messages
alarm
Alarm messages only
alarm+trbl
Alarm and trouble messages
alarm+o/c
Alarm messages, including arming & disarming
alarm+alrt
Alarm and alert messages
alarm+alrt+trbl
Alarm, alert and trouble messages
alarm+alrt+o/c
Alarm and alert messages, including arming & disarming
alarm+trbl+o/c
Alarm and trouble messages, including arming & disarming
alert
Alert messages only
alert+o/c
Alert messages, including arming & disarming
alert+o/c+trbl
Alert and trouble messages, including arming & disarming
alert+trbl
Alert and trouble messages
trouble
Trouble messages only
trouble+o/c
Trouble messages, including arming & disarming
open/close
Arming and disarming (open/close) only
14
The display shows the currently selected option (indicated by a
◼
symbol), for example, " disable report ".
Using the or buttons you can now select the events you wish to be reported to MMS
telephones numbers according to the options provided in the tables below:
Event Group Option
Events to be reported
alarms+alrt
Alarm and alert messages
alarm
Alarm messages
alert
Alert messages
disable report
No message will be reported
15
You can now, select other options, end this session – (see section A.1 and section A.2), or quit
programming (see section A.3).
B.13 Enabling / Disabling the Squawk Option
The PowerMaster system (and its wireless sirens) can be set to produce a short "Squawk" of audible feedback
to assist you when you use your keyfob to arm (1 beep) and disarm (2 beeps) the PowerMaster system
(operates in a similar manner to a car alarm).
 Here you can enable / disable the Squawk.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
1.
SQUAWK
Enter the [USER SETTINGS] menu, select the [SQUAWK] option and press
.
1
Squawk on ◼
The display shows the currently selected setting.
2
2.
or
Click the or button until the display reads the desired
setting, for example, "Squawk OFF" and press the button to confirm.
Squawk OFF
3.
Squawk OFF ◼
A "Success Tune" ☺ sounds. The display confirms the saved setting, and
then returns to the User Settings menu, step 1.
3, 4
☺ Return to step 1
Additional Information (section B.13)
1
For detailed instructions on how to select User Settings – refer to sections A.1 and A.2.
2
a. The display shows the currently selected setting (indicated by a
◼
symbol), for example, [ Squawk ON ].
b. You can now enable (ON) or disable (OFF) the Squawk option using the or button.

Visonic PM-10 TRIPLE Specifications

General

Brand	Visonic
Model	PM-10 TRIPLE
Category	Control Systems
Language	English