EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
D-307502 PowerMaster-10/30 G2 User's Guide 53
Event notifications by SMS
Note: This feature is not to be not to be enabled in UL Listed product.
The PowerMaster system when equipped with a GSM unit can be programmed to send SMS event notification
messages to 4 pre-selected telephone numbers - see Chapter – 6, B.11. The messages can be tagged with a
"House ID" name, for example, "JOHN'S HOUSE", see Remote Control by SMS section, command no. 10.
Example of the reported SMS messages:
• JOHN’S HOUSE
**AWAY**
• JOHN’S HOUSE
**DISARM**
• JOHN’S HOUSE
POWERMASTER: LOW BATTERY
GARAGE: LOW BATTERY
• JOHN’S HOUSE
STATUS MESSAGE 01
(Event list is displayed)
Note: Status messages can be sent only to a calling telephone whose identity number is not blocked by the user!
Remote Control by Telephone
Note: This feature is not to be not to be enabled in UL Listed product.
The PowerMaster allows you to initiate calls from your private telephone to the PowerMaster control panel via
PSTN (landline) or GSM and to perform a variety of arming commands remotely using your telephone's keypad.
To connect to the PowerMaster when the PowerMaster is connected to the PSTN:
1. Dial the PowerMaster PSTN tel. No.
2. Wait for 2-4 rings then hang up.
1
3. Wait 12-30 sec.
4. Redial PowerMaster tel. No. (sound will be heard for 10 sec.).
5. [*] (to stop the sound)
6. [User code], [#]
2
7. [Desired command]
To connect to the PowerMaster when the PowerMaster is connected to the GSM:
1. Dial the PowerMaster GSM tel. No. (sound will be heard for 10 sec.)
2. [*] (to stop the sound)
3. [User code], [#]
2
4. [Desired command]
Notes:
(1) Entering of user code is required once only.
(2) If you wait more than 50 seconds (may change according to setup / use) without keying a command, the
PowerMaster will disconnect the line.
A. Executable Commands
To Next Page
Loading...
Need help?
General