European Standards:
The PowerMaster G2 control panels are compatible with:
EN 300220, EN 301489, EN 50130-4, EN 60950-1, EN 50130-5, EN 50131-3EN 50131-6, EN 50136-1, 2,
The PowerMaster-10 Triple G2: EN 50131-4, EN 50131-10
The PowerMaster-30 G2: EN 50131-4
According to the European standard EN50131-1 and EN 50131-3, the PowerMaster G2 security grading
is Grade 2 - "low to medium risk" and environmental classification is Class II – "indoor general"
According to EN 50131-6 the power supply type is A.
The PowerMaster-10 Triple G2 and PowerMaster-30 G2: ATS Category - DP4 when IP module primary
SPT and GPRS- alternative SPT, according to EN50136-1 and Pass-through Operation Mode according
to EN50136-2
PowerMaster-10 Triple G2: according to EN 50131-10 – Supervised Premises Transceiver (SPT) Type Z
UK standards:
This product is suitable for use in systems installed to conform to PD6662:2010 at Grade 2 and
environmental class 2. DD243 and BS8243.
Applica T&C:
The PowerMaster-10 Triple G2 ATS Categories –DP4, Environmental Class II, Security Grade 2, and
SPT type Z
The PowerMaster-30 G2- ATS Categories –DP4, Environmental Class II, Security Grade 2
Certified by Applica T&C in accordance with
EN 50131-1, EN 50131-3, EN 50131-6, EN 50131-5-3, EN 50130-5,
EN 50130-4, EN 50136-1, EN 50136-2
PowerMaster-10 Triple G2- EN 50131-10
Applica T&C has certified only the 868 MHz variant of this product.
U.S. Standards: PowerMaster-10 G2 and PowerMaster-30 G2
FCC- CFR 47 part 15 and part 68, UL 1023 and UL 985
Canada Standards: PowerMaster-10 G2 and PowerMaster-30 G2
IC- RSS 210, ULC-C1023, ULC-S545-02
Note: Only devices operating at 912-919 MHz are tested and listed by UL/ULC.
SIA CP01 standards:
PowerMaster-10 G2 and PowerMaster-30 G2: for SIA CP01, a siren must be used in the system
installation.
GSM standards:
Europe: Complies with CE standards: EN 301 511, EN301 489-7
USA: CFR 47 Part 22 (GSM850) and Part 24 (GSM 1900).
This device complies with Part 15 of the FCC Rules and with ISED license-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélecTripleque subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
To comply with FCC and IC RF exposure compliance requirements, the device should be located at a distance of at least
20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated
in conjunction with any other antenna or transmitter.
Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de son
fonctionnement normal. Les antennes utilisées pour ce produit ne doivent pas être situés ou exploités conjointement
avec une autre antenne ou transmetteur.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
To Next Page
Loading...
Need help?
General