Visonic PM-10 TRIPLE User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
D-307502 PowerMaster-10/30 G2 User's Guide 51
B.17 PowerLink Parameters*
The PLNK curr.params menu shows the current IP address, subnet mask, default gateway and current mode of
communication. The PowerLink information is for support purposes only.
 Here you can see the current IP address of the PowerLink and other relevant data.

Carefully read the section titled "Additional information" according to the indicated references
1
etc. – see
table at end of this section.
1.
PLNK curr.params
Enter the [USER SETTINGS] menu, select the [PLNK curr.params]
option and press .
1
2.
Curr.IP address
Displays the current PowerLink IP address.
xxx.xxx.xxx.xxx
3.
Curr.subnet mask
Displays the current PowerLink subnet mask.
xxx.xxx.xxx.xxx
4.
Current Gateway
Displays the current PowerLink default gateway.
xxx.xxx.xxx.xxx
☺ Return to step 2
2, 3
*If the Broadband Module is not registered to the PowerMaster, this menu is not displayed.
Additional information (section B.15)
1
For detailed instructions on how to select the Setting Options – refer to sections A.1 and A.2.
2
To end this session and return to previous menu options, press the button.
3
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).

Visonic PM-10 TRIPLE Specifications

General

Brand	Visonic
Model	PM-10 TRIPLE
Category	Control Systems
Language	English