Visonic PM-10 TRIPLE User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
D-307502 PowerMaster-10/30 G2 User's Guide 35
B.10 Enabling / Disabling Auto-Arming
The PowerMaster system can be programmed to automatically arm itself on a daily basis at a predetermined
time. This feature is useful especially in commercial applications, such as in stores, to ensure that the system is
always armed and without having to assign security codes to employees.
 Here you can enable (activate) and disable (stop) the Auto-Arming. To set the Auto-Arming time –
see section B.11.
 Auto-arming can arm a "NOT READY" system only if forced arming is enabled by the installer while
programming your system.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
1.
AUTO-ARM ENABLE
Enter the [USER SETTINGS] menu, select the [AUTO-ARM ENABLE] option
and press .
1
enable autoarm◼
The display shows the currently selected setting.
2
2.
or
Click the or button until the display reads the desired
setting, for example, [disable autoarm] and press to confirm.
disable autoarm
3.
☺ Return to step 1
A "Success Tune" ☺ sounds. The display confirms the saved setting, and
then returns to the User Settings menu, step 1.
3
B.11 Setting the Auto-Arming Time
 Here you can program the exact time of the Auto-Arming.
Note: This feature is not to be not to be enabled in UL Listed product.
1.
AUTO-ARM TIME
Enter the [USER SETTINGS] menu, select the [AUTO-ARM TIME] option
and press .
1
2.
arm time 12:00P
The display shows the current setting of the Auto-Arm Time. At the blinking
cursor position, enter the correct time, for example, “8:30A”, using the
numerical keypad.
4
3.
When you are satisfied with the setting, press to confirm.
TIME 08:30A
A "Success Tune" ☺ sounds. The display confirms the saved time, then
returns to the User Settings menu, step 1.
5, 6
☺ Return to step 1
Additional Information (section B.10 - section B.11)
1
For detailed instructions on how to select User Settings – refer to sections A.1 and A.2.
2
The display shows the current setting (indicated by a
◼
symbol), for example, [ enable autoarm ]. You can
now select either to enable or disable auto-arming using the or button.
3
The
◼
symbol now appears next to the newly selected option.
4
The display shows the current setting of the Auto-Arm Time, for example, " 12:00 PM ", with the cursor
blinking on the first hour digit "1". For detailed explanation of how to set the time - refer to SectionB.8 B.
5
The saved auto arm time is displayed without the cursor, for example, " 08:30 A ".
6
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).

Visonic PM-10 TRIPLE Specifications

General

Brand	Visonic
Model	PM-10 TRIPLE
Category	Control Systems
Language	English