Visonic PM-10 TRIPLE User Manual

OPERATING THE POWERMASTER SYSTEM
12 D-307502 PowerMaster-10/30 G2 User's Guide
PRESS
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
Code
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
Vacate the premises
 (Exit delay) 
AWAY
ARM indicator lights during the armed state.
Forced Arming AWAY or HOME
Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be
bypassed for the duration of arming.
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:
PRESS
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
[Enter code] /
[Present tag]
Code / Present tag
ARMING AWAY
PLEASE EXIT NOW
(to mute the buzzer)
Vacate the premises
 (Exit delay) 
AWAY
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!
Forced arming “HOME” is performed in a similar manner, as follows:
PRESS
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
[Enter code] /
[Present tag]
Code / Present tag
ARMING HOME
PLEASE EXIT NOW
(to mute the buzzer)
Go to interior zone
 (Exit delay) 
HOME HH:MM
ARM indicator flashes during the armed state.

Visonic PM-10 TRIPLE Specifications

General

Brand	Visonic
Model	PM-10 TRIPLE
Category	Control Systems
Language	English