Technical Reference Manual-XPM3m Revision Date: August 2014
RECONNECTING THE CONVEYOR BELT
1 Retrieve the single master link previously removed. Hold the master link so that the opening faces
you and the curve in the link matches the curve in the belt. Insert the link into the belt so the hooks
go into the two links surrounding the center link.
2 Hook the right hook into the center link of the bottom belt edge. Push the link back into place and
using a screwdriver, connect the left hook to the center link of the bottom belt edge.
3 Grasp a triple link and squeeze it into a U shape. While holding this shape, slide the ends of the
triple master link into the belt. Release the ends of the master link.
4 Grasp the other triple master link and squeeze it into a U shape. While holding the U shape, slide
the ends of the master link into the belt. The master links should now be connecting the two belt
ends.
5 At the right side of the belt, using a screwdriver, hook the master link right hook into the last hook of
the belt (insert the master link hook from the top). Then using a screwdriver connect the master
link right hook into the first link on the bottom edge of the belt.
6 Using a screwdriver slide the left side of the same master link into the belt. Then, using the
screwdriver, connect the left master link hook to the belt, inserting the hook from the underside of
the belt.
7 At the left side of the belt, using a screwdriver, hook the master link left hook into the last hook on
the belt (insert the master link hook from the top). Then using a screwdriver connect the master
link left hook to the belt.
8 Using a screwdriver, slide the right side of the same master link into the belt. Then, using the
screwdriver, connect the right master link hook to the belt, inserting the hook from the underside of
the belt.
End of procedure.
To Next Page
Loading...
