Vox Lil Looper - Overdubbing Control Functions; Overdubbing Undo;Redo

23
Creating phrases
3. AdjustthevolumeofLoop1withtheLOOP
LEVEL/VALUEknob.
The volume balance of the loop and instrument
will be adjusted.
4. Atthepointwhereyouwanttostartoverdubbing,
presstheLOOP1pedal,andplayyourinstrument.
The Loop 1 REC status LED will light-up red, and
overdubbing will begin.
5. PresstheLOOP1pedalatthepointwhereyou
wanttostopoverdubbing.
The Lil' Looper will switch from overdubbing to
loop playback.
6. PresstheLOOP1pedaltwicetostopLoop1
playback.
Overdubbing undo and redo functions
If a loop is stopped, the undo and redo information
will be deleted.
Undo function
Execute this function when you want to delete the
contents that were overdubbed last.
1. HolddowntheLOOPpedalduringplaybackor
overdubbing.
2. ReleasethepedalwhenthePLAYstatusLED
blinksorange.
The undo function will be executed.
If new overdubbing is performed over the recording
that was just undone, the previous content will be
deleted.
Redo function
The Undo function will be cancelled, and the previous
status will be restored.
1. Fromtheprocedurethatwasundone,holddown
theLOOPpedal.
2. ReleasethepedalwhenthePLAYstatusLED
blinksgreen.
The redo function is executed.