Handset speakerphone
During a call, press to switch between speakerphone and normal
handset use.
Volume control
During a call, press /VOL or /VOL to adjust the listening volume.
Mute
The mute function turns off the microphone. You can hear the caller, but the
caller cannot hear you.
To mute a call:
Press MUTE/
REMOVE to turn off the microphone. The screen shows
Muted for a few seconds and MUTE appears until the mute function is
turned off.
To un-mute a call:
Press MUTE/
REMOVE again to resume the conversation. The screen
temporarily shows Microphone ON.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to touch
tone dialing temporarily during a call. This is useful if you need to send touch
tone signals to access your telephone banking or long distance services.
During a call:
Press TONE
.
Use the dialing keys to enter the relevant number. The telephone sends
touch tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
•
•
1.
2.
3.
42
Telephone operation
Hold
You can place a home or cell call on hold. You will hear an alert tone if you
have not taken the call off of hold after 14 minutes. You will hear another
alert tone 30 seconds later. At 15 minutes on hold, the call on hold
automatically disconnects.
To place a home call on hold:
Press HOLD on the handset. Home call on hold appears and
/HOME/FLASH
ƀCUJGU
To resume a home call on hold:
Press
/HOME/FLASH
.
To place a cell call on hold:
Press HOLD on the handset. Cell call on hold appears and
/CELLƀCUJGU
To resume a cell call on hold:
Press /CELL.
Handset locator
6JKUHGCVWTGJGNRU[QWſPFCOKURNCEGFJCPFUGV
To start paging:
Press FIND HANDSET on the telephone base
when it is not in use. All idle handsets ring and
display
**
Paging
**
.
To end paging:
Press FIND HANDSET on the telephone base.
- OR -
Press
/HOME/FLASH, or any dialing keys (0-9, #,
TONE
) on
the handset.
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
