10
GM 5000EA
OPERATING MANUAL
EDITION 04/2016 ORDER NUMBER DOC2344499
2 CORRECT USE
2.1 DEVICE TYPE
Electrostatic manual spray gun for manual coating of grounded work pieces.
2.2 TYPE OF USE
The GM 5000EA electrostatic manual spray gun is suitable for spraying liquid products,
particularly coating products, using the air atomizing method. Coating products which
contain ingredients of explosion class IIA and IIB substances (maximum ignition energy
0.24 mJ) may be used.
WAGNER forbids any other use!
2.4 SAFETY PARAMETERS
2.3 USE IN AN EXPLOSION HAZARD AREA
The GM 5000EA electrostatic manual spray gun is suitable for coating electrically
conductive objects with liquid coating products and can be used in potentially explosive
areas (see explosion protection marking in Chapter 3).
WAGNER accepts no liability for any damage arising from incorrect use.
Use the device only to work with the products recommended by WAGNER.
Only operate the device as a whole.
Do not deactivate safety xtures.
Use only WAGNER original spare parts and accessories.
The device may only be operated under the following conditions:
The operating personnel must be trained on the basis of this operating manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance and repair information in this operating manual must be
observed.
The statutory requirements and accident prevention regulation standards in the
country of use must be observed.
The electrostatic manual spray gun may only be operated if all parameters are set and all
measurements/safety checks are carried out correctly.
To Next Page
Loading...
Need help?
General
