29
GM 5000EA
B_00180
OPERATING MANUAL
EDITION 04/2016 ORDER NUMBER DOC2344499
5.5.2 SPRAYING PROCEDURE FOR FLAT JET AIR ATOMIZING
Shaping air
Air cap
Spray pattern
Atomizing air
Advantages
- Large range of adjustment of the spray jet
- Thin layers
- Uniform coating thickness
- Perfect nish
Spray product Spray angle
In this process, the spray product is fed to the nozzle at a pressure of 0.05–0.2 MPa; 0.5–2 bar; 7–29 psi. The
atomizing air at approx. 0.25 - 0.4 MPa; 2.5 - 4 bar; 36 - 58 psi produces a soft round jet, which largely eliminates
the problem of overlapping boundaries. The shaping air allows modi cation of the spray jet. There are various
nozzles and air caps available as accessories for the respective spray product and the discharge quantities.
To Next Page
Loading...
