WAGNER PC 1025 PRO - English

27
PC 1025 PRO
EN
Table of Contents
1 SAFETY REGULATIONS ______________________ 28
2 INTRODUCTION TO WORKING WITH THE
MORTAR SPRAYING MACHINE PC 1025PRO ____ 29
2.1 Function of the mortar spraying machine
PC 1025Pro _________________________________ 29
2.2 Processible coating materials ___________________ 30
3 TECHNICAL DATA ___________________________ 30
4 EXPLANATORY DIAGRAM FOR PC 1025PRO ____ 31
4.1 Operating elements and displays on device _______ 32
4.2 Drive _______________________________________ 32
4.3 Compressor (accessory) _______________________ 33
4.4 Mortar hose _________________________________ 33
4.5 Spray lance _________________________________ 33
5 TRANSPORTATION __________________________ 34
5.1 Moving _____________________________________ 34
5.2 Transport using a crane (g. 4) __________________ 34
5.3 Transportation in vehicle ______________________ 34
6 COMMISSIONING ___________________________ 34
6.1 Installation location ___________________________ 34
6.1.1 Connection to mains power supply/ Extension cable 34
6.2 Initial starting-up _____________________________ 34
6.2.1 Scope of supply ______________________________ 34
6.2.2 Assembly (g. 5) _____________________________ 35
6.3 Connecting the mortar hose ___________________ 35
6.4 Compressor (accessory) _______________________ 35
6.5 Connecting the spray lance (g. 8) _______________ 36
6.6 Preparing the mortar spraying machine (g. 9) _____ 36
6.7 Beginning of the spraying process _______________ 37
6.8 End of the spraying process ____________________ 37
7 GENERAL INFORMATION ABOUT THE
APPLICATION TECHNIQUE ___________________ 37
7.1 Spraying technique ___________________________ 37
8 SHUTTING DOWN AND CLEANING ____________ 38
8.1 Cleaning the mortar hose ______________________ 38
8.2 Cleaning the device and replacing the stator ______ 38
8.3 Cleaning the spray lance _______________________ 39
8.4 Air lter (accessory) ___________________________ 39
9 MAINTENANCE _____________________________ 40
9.1 Mechanical maintenance ______________________ 40
9.2 Electrical maintenance ________________________ 40
9.3 Long periods of non-usage _____________________ 40
9.4 Shaft seal (g. 14) ____________________________ 40
9.5 Seals _______________________________________ 41
9.6 Rotor replacement (g. 16) _____________________ 41
10 ELIMINATING FAULTS ________________________ 42
11 SPARE PARTS LIST FOR PC 1025PRO ___________ 45
11.1 Spare parts list frame _________________________ 46
12 SPARE PARTS LIST OF SPRAY LANCE __________ 46
13 PC 1025PRO ACCESSORIES ___________________ 47
Testing of the mortar spraying machine _______________ 48
Important information on product liability_____________ 48
Note on disposal __________________________________ 48
Wagner Standard Guarantee ________________________ 48
Service network __________________________________ 52
TABLE OF CONTENTS