WAGNER PC 1025 PRO - Page 44

44
PC 1025 PRO
EN
If the defect is not caused by one of the above-mentioned faults, have the defect eliminated by the WAGNER customer service.
MALFUNCTION POSSIBLE CAUSE ELIMINATION
Pressure at the manometer rises
to more than 40 bars.
Viscosity of the coating material too
high.
Mortar hose diameter too small.
Mortar hose is too long.
Coating material “plug” in the mortar
hose. Mortar hose not prerinsed with
cellulose paste.
Dilute the coating material.
Use a mortar hose with a larger diameter.
Use a shorter mortar hose.
Depressurize the mortar hose – set the selector
switch to “R” (reverse).
Pump the coating material back into the con-
tainer.
The mortar hose must be pres-
sureless.
Watch the manometer ––> 0 bar.
Wear safety goggles.
Decouple mortar hose and rinse with water hose.
When the plug has been removed, ll cellulose
paste in the mortar hose. Couple the mortar hose
back on.
Mortar spraying machine does
not pump enough coating ma-
terial.
Convey capacity selected too low.
Mortar hose diameter too small.
Stator worn.
Texture tip too small.
Set the volume regulator higher.
Use a mortar hose with a larger diameter.
Mount a new stator, if necessary, also a new rotor.
Attention: Spray on pump sliding means.
Select a larger texture tip.
Rule of thumb: Granular size x 3 ––> Tip size
ELIMINATING FAULTS