36
PEM-X1
OPERATING MANUAL
VERSION 03/2014 ORDER NUMBER DOC 2326020
8.2 MAINTENANCE
Maintenance work should be undertaken regularly and carefully by quali ed and trained
sta . They should be informed of speci c hazards during their training.
The following hazards may arise during maintenance work:
Health hazard from inhaling powder lacquer
Use of unsuitable tools and aids
Once the maintenance work is complete, the device must be checked by a quali ed person
to ensure a reliable condition.
8.2.1 MAINTENANCE STAFF
8.2.2 SAFETY INSTRUCTIONS
Incorrect maintenance/repair!
Risk of injury and damage to the device.
Have repairs and part replacements carried out only by specially
trained sta or a WAGNER service center.
Before all work on the device and in the event of work
interruptions:
- Switch o the energy/compressed air supply.
- Relieve spray gun and device pressure.
- Secure the spray gun against actuation.
Observe the operating manual and service manuals at all times
when carrying out work.
DANGER
Incorrect maintenance/repair!
Danger to life and damage to the device.
Repair or replacement of devices or parts of devices are only
allowed to be performed outside the hazard area by quali ed
personnel.
Before starting maintenance or other manual work, the high-
voltage must be shut down and locked to prevent it from being
switched back on!
The spray gun must be separated from the high-voltage supply
and compressed air supply before any maintenance work is
started!
DANGER
To Next Page
Loading...
Need help?
General
