9
PEM-X1
OPERATING MANUAL
VERSION 03/2014 ORDER NUMBER DOC 2326020
2.4 SAFETY PARAMETERS
WAGNER accepts no liability for any damage arising from non-intended use.
Electrostatic manual coating systems may only be operated in an undamaged condition.
Damaged devices must be decommissioned immediately and repaired immediately.
Use the device only to work with the products recommended by WAGNER.
Operate only the device as a whole.
Do not deactivate safety ๎ xtures.
Spare parts and accessories may have safety-relevant properties.
Use only WAGNER original spare parts and accessories.
The manual powder spray gun may only be operated under the following conditions if:
the operating sta๎ have previously been trained on the basis of this operating manual,
the safety regulations listed in this operating manual are observed,
the operating, maintenance and repair information in this operating manual is observed,
and the statutory requirements and accident prevention regulations standards in the
country of use are observed.
2.5 PROCESSIBLE WORKING MATERIALS
Types of powder which can be charged electrostatically
Metallic powder
To Next Page
Loading...
Need help?
General
