2-20 Preparing for operation
Selecting the solvents for priming
4. Select the solvents you plan to run. Choose solvent A1 or A2, and then
choose solvent B1 or B2.
5. In the Flow Rate (mL/min) field, enter the solvent flow rate for the
priming run.
6. In the Time (min) field, enter the number of minutes for priming.
7. Click Prime. The values you enter in the Flow Rate (mL/min) and Time
(min) fields become the defaults for the binary gradient module.
8. To stop priming, press the Stop button on the front panel.
Priming continues until you press the Stop button.
To Next Page
Loading...
