Confirm the Water Supply is On
Water is supplied to WAZER Pro during operartion. Double-
check that the On/Off Valve is on. It is critical to not overlook
this step. Running WAZER Pro without the water supply turned
on will damage the Pump.
If you do happen to attempt to cut a file without the water on,
you will immediately notice that something is wrong. In this
case, DO NOT panic. Pause WAZER Pro, turn the water supply
on and start your Cut. More on how to pause WAZER Pro later.
Fasten the Material
Securely fastening the Material to the Cut Bed is critical to the accuracy of your desired Cut. If your Material
moves during cutting, the results the cutting results will be poor, or fail completely.
You can use any fasteners that are about 5 mm in diameter to secure your materials to the corrugated Cut Bed.
Be mindful of the Nozzle profile and the screw head size you choose to minimize Nozzle crashes and losing a
Cut.
To fasten your Material
• Perform a quick check to make sure that the Material is large enough to accommodate the shape you want to
cut.
• Fasten the Material with the Fastening Screws in the Spare Parts bag, confirming that it cannot slide in any
direction. You can insert a screw into any of the holes in the Cut Bed. Confirm task completion by pressing “OK”
on the Control Panel.
• If this is your first cut, there is already a piece of 4mm aluminum plate fastened on your cut bed. This is your
"Welcome cut material". Slide it in several directions to ensure it is secured.
To set the Nozzle Height:
Cutting With WAZER Pro |
SECTION 5
51
To Next Page
Loading...