Configuration of the PLC300
PLC300 | 7-3
The arrows select the mode that is activated only if <ENTER> is pressed.
<ESC> exits without changing the mode.
Analog Input
--------------------
Voltage 0 to 10V
7.6 IOA CARD (AOS)
Selects one of the four operating modes of the analog outputs (AOs) of the IOA accessories
installed, seeing that the AOs 101 and 102 are the AOs 1 and 2 of the IOA card installed in
the slot 1 of the PLC300, and the AOs 201 and 202 are the AOs 1 and 2 of the IOA card
installed in the slot 2.
IOA Card (AOS)
--------------------
>AO101:0 to 10V
AO102:0 to 10V
The arrows <> and <> select the AO to be changed. By pressing <ENTER>, the cursor
flashes in the operating mode to be changed.
The arrows <> and <> browse through the possible operating modes:
0 to 20 mA, 4 to 20 mA, 0 to 10 V and -10 to +10 V.
<ENTER> accepts the changed value. <ESC> aborts.
<ESC> returns to the main menu of the setup.
7.7 ENCODER SUPPLY
Selects the power supply of the encoder between 5 or 12 V.
The arrows select the wanted voltage, which becomes valid only if <ENTER> is pressed.
<ESC> exits without changing the encoder voltage.
Encoder Supply
--------------------
Encoder 12V
7.8 RS-232 SETUP
It is possible to configure the baud rate, the parity and the number of stop bits of the RS-
232 serial interface.
To Next Page
Loading...
