Configuration of the PLC300
7-10 | PLC300
The menu output is executed by timeout, i.e., in about 10 s without operation, the PLC300B
display will show the status of the I/Os again.
EDITING OF THE EQUIPMENT NUMBER (BLIND VERSION, WITHOUT HMI)
To edit the number of the equipment, press the key for some seconds, then the cursor
flashes on the number.
The number of the equipment always goes back to 0001 when it enters the editing mode
in the blind version (without HMI).
Short strokes on the key will increment the number; if the key remains pressed, the number
is increased rapidly.
To accept the entered value, simply release the key; in about five seconds the editing mode
is completed, maintaining the current value and returning to the backup menu.
7.14 USER PROGRAM
Allows to stop or execute the user program.
The current status of the program is also shown.
The <ENTER> key selects between ‘Stop’ or ‘Run’.
User Program
--------------------
Status:Running
>Stop
In the option ‘Stop’ or ‘Execute’ ENTER or arrows, toggles the value, that is, if the program
is running the message ‘Stop’ changes to ‘Execute’ and the program is stopped.
<ESC> returns to the main menu of the setup.
7.15 SETUP MENU PASSWORD
Allows changing the password of the setup function.
The standard password is ‘0000’. The new password must be a number with four digits.
Change SETUP Passwd
--------------------
New password:
Type the new password and press <ENTER>.
The arrow <> or <DEL> keys serve as backspace.
To Next Page
Loading...
