Configuration of the PLC300
PLC300 | 7-5
Address: 1 to 247.
In the editing of the address, in addition to the upward and downward keys, the number can be
typed directly by the numeric keyboard. The <DEL> key returns to the initial value, with no change.
<ENTER> accepts the changed value. <ESC> aborts.
<ESC> returns to the main menu of the setup.
7.10 CAN SETUP
It is possible to configure the baud rate and the address of the PLC300 in a CANopen
network, through the CAN Interface.
The arrows <> and <> select the option to be changed. By pressing <ENTER>, the
cursor flashes in the operating mode to be changed.
CAN Setup
--------------------
>Baud Rate:1Mbps
Address :001
The arrows <> and <> browse through the possible values:
Baud rate: 20, 50, 100, 125, 250, 500 (Kbps), 1 Mbps
Address: 1 to 127
In the editing of the address, in addition to the upward and downward keys, the number
can be typed directly by the numeric keyboard. The <DEL> key returns to the initial value,
with no change.
<ENTER> accepts the changed value. <ESC> aborts.
<ESC> returns to the main menu of the setup.
7.11 LAN SETUP
It is possible to configure the IP address, subnet mask, default gateway, DHCP, speed and
duplex mode of the PLC300 in an Ethernet network.
LAN Setup
--------------------
>IP Address:
192.168.000.010
Subnet:
255.255.255.000
Gateway:
000.000.000.000
DHCP:
Disabled
Speed/Duplex:
Auto
To Next Page
Loading...
