上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
NcEditor V12 Laser Cutting CNC System
Manufacturer Manual
Version: 2019.3 1st Version
Author: Document Department
Weihong Corporation, All Rights Reserved
1 CNC System Installation ............................................................................................................... 2
1.1 Install Hardware ............................................................................................................ 2
1.2 Install Software ............................................................................................................... 6
1.3 Install Driver .................................................................................................................... 9
1.4 Install a Camera ........................................................................................................... 12
2 Interface Overview ...................................................................................................................... 14
2.1 Toolbar ............................................................................................................................ 16
2.2 Drawing Window ........................................................................................................ 17
2.3 Running Information Bar ......................................................................................... 18
2.4 Window Display Buttons ......................................................................................... 19
2.5 Machine Control Area ................................................................................................ 19
2.6 Status Bar ....................................................................................................................... 25
2.7 Drawing Toolbar ......................................................................................................... 26
2.8 3D View Area ................................................................................................................ 26
3 Machine Tool Commissioning ................................................................................................. 28
3.1 Modify Port Polarity................................................................................................... 28
3.2 Set Drive Parameters ................................................................................................. 28
3.3 Adjust Pulse Equivalent and Electronic Gear Ratio ....................................... 50
3.4 Set Speed Parameters ................................................................................................ 52
3.5 Adjust the Axis Direction ......................................................................................... 52
3.6 Set the Workbench Stroke ....................................................................................... 53
To Next Page
