上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
25 / 144
• : Lead light
Used to turn on red light manually, which is a kind of guide light.
Red light is used to point out the position of laser on the sheet.
• : Exchange workbenches
Used to exchange workbenches, so as to improve the machining efficiency.
• : Release
Used to manually control the machine tool to release workbenches during
exchanging workbenches.
2.5.6 Machining Selection Area
It includes the following:
• : Machine selected objects
Used to machine the selected objects, including machining, dry run, simulation,
cutting frame, machining from the near point and breakpoint resume.
• : Cutting at jog
Used to manually control the machine tool with laser on.
• : Resume without piercing
Used to execute breakpoint resume without piercing during cutting a thick
sheet, so as to avoid damage to the sheet and effect on machining.
• : Find edges
Used to find edges automatically before machining.
2.6 Status Bar
It is used to show the following:
• Related information of current drawing objects: drawing steps and meaning,
step result, tuning distance, etc.
• Tips during machining.
To Next Page
Loading...
