上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
6 / 144
1.2 Install Software
This section introduces how to install software of NcEditor V12 Laser Cutting CNC
System, hereinafter referred to as NcEditor software.
Before installing the software, note the following:
• There must be a D disk in your computer, otherwise the installation will fail.
• NcEditor software is installed under directory C:\Program
Files\Weihong\NcEditor by default.
• If it is your first time to install the software, you need to install the basic
environment package first:
To install the software, do the following (If it is your first time to install the software,
skip steps 6 and 7):
1. Copy the installation package to your computer.
2. Unzip the installation package and double click . NcEditor Setup dialog
box pops up.
3. According to the prompt, select the display language between Chinese and
English.
4. According to the prompt, click Yes to start to update the system.
5. Optional: Close the running NcEditor software when a prompt Waiting for
closing NcEditor pops up.
To Next Page
Loading...
Need help?
General
