上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
61 / 144
4 Follow-up
This section introduces follow-up in NcEditor V12 Laser Cutting CNC System,
which is used to move Z-axis up and down in real time through the corresponding
relationship between capacitance and distance and ensure the relative distance
between the cutting head and the workpiece is unchanged.
It introduces follow-up from the following aspects:
• Interface overview
• Commissioning steps
• List of parameters
• FAQs
4.1 Interface Overview
In this section, you can quickly get familiar with Follow-up Control dialog box and
execute related operations.
To open Follow-up Control dialog box, do one of the following:
• In drawing toolbar, click .
• In menu bar, click System → Follow Control.
You can switch between the following interfaces by clicking the buttons on the left:
• System interface
To Next Page
Loading...
