上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
60 / 144
3.9.3 Check Laser Technics
This operation is used to check whether the technic control of piercing is normal.
It includes the following:
• Whether the state of ports like laser, blow, follow-up and burst is the same with
the actual situation.
• Whether parameters of time sequence is correct. See Layer Function for details.
• Whether parameters of laser technics in Layer Setting dialog box are
appropriate, like time sequence and delay of follow-up, blow and laser. See
Layer Function for details.
• Whether voltage change of the laser power control port AVC correlates with
laser power change.
To Next Page
Loading...
