WEIHONG NcEditor V12 - Drawing Toolbar; View Area

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
26 / 144
2.7 Drawing Toolbar
It is used to do the following:
• Draw objects
• Execute auxiliary editing operations
• Execute basic editing operations
• Set technics
• Set layers
• Nest toolpaths
• Find edges
2.8 3D View Area
It includes the following:
• View area
• View toolbar
2.8.1 View Area
It is used to check the tube from different perspectives and preview cutting effect.
In this area, you can do the following:
• Press the left button:
– To rotate the tube, drag the mouse left and right.
– To move the tube, drag the mouse up and down.
• To zoom in/out the tube, scroll the mouse wheel.
2.8.2 View Toolbar
It includes the following:
• : Switch view
Used to observe a tube from different perspectives.
• : Rotate CW
Used to rotate the view in a clockwise direction.
• : Rotate CCW
Used to rotate the tube view in a counterclockwise direction.