上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
2 / 144
1 CNC System Installation
This section introduces how to install NcEditor V12 Laser Cutting CNC System,
including the following:
• Install hardware
• Install software
• Install driver
• Optional: Install a camera
1.1 Install Hardware
This section introduces how to install hardware of NcEditor V12 Laser Cutting
CNC System.
Before installing hardware, do the following:
• Check configuration.
• Confirm installation space.
To install hardware, do the following:
• Connect hardware.
• Install motion control card.
To get details of wiring inside hardware, see Wiring Diagram of Terminal Board,
Wiring Diagram of Drive and Wiring Diagram of Laser Device.
1.1.1 Check Configuration
To check whether the hardware that you have received is complete and correct, see
the following list:
• PM95A motion control card
• Lambda 5E terminal board
• EX30A terminal board (in position loop control mode) / EX33A terminal board
(in velocity loop control mode)
• EX31A terminal board (optional when exchanging workbench)
• SE001 follow-up amplifier
• Two DB9M/F communication cables
• One radio frequency cable
• One M16 tow cable with 4-core air plug
• WHB05S wireless handwheel / WHB05L wireless handwheel
To Next Page
Loading...
Need help?
General
