上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
5 / 144
1.1.3 Install Motion Control Card
NcEditor V12 Laser Cutting CNC System uses PM95A motion control card to mate
with NcEditor software, so as to control laser cutting rapidly and accurately.
Before installing motion control card, check whether the computer meets the
requirement according to the following list:
• CPU: basic frequency 1G or above
• Memory: above 1G
• Hard disk: above 20G
• Display adapter: 1024*864 at least (longitudinal resolution ≥ 864)
• Display: above VGA 14"
• CD-ROM: 4X or higher (optional)
• Main board extension slot: 1 or more PCI/PCIE slot
To install motion control card, do the following:
1. Power off the host computer and open the computer case.
2. Insert the motion control card into the PCI/PCIE slot.
3. Tighten the mounting screw and lid the computer case.
4. Restart the computer.
If NcEditor software cannot be run normally after the motion control card and
driver are installed, turn off the computer and check the connecting finger:
• If it is not clean, clear it with an eraser.
• If it is clean, change the motion control card.
To Next Page
Loading...
Need help?
General
