WEIHONG NcEditor V12 - Advanced Function Parameters

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
109 / 144
5.4 Advanced Function Parameters
This section introduces parameters of advanced function under Advanced
Function category, including the following:
• 4.0 Habitual Setting
• 4.1 Simulation
• 4.2 Fixed Point
• 4.3 Resume
• 4.4 Leap Frog
• 4.5 Scan Cutting
• 4.7 Edge Finding
5.4.1 Habitual Setting
Prompt Type When Tack End
Red light is on after machining.
0: No prompt
1: Res light on for 3s
2: Red light always on until there is input from mouse or keyboard
Default value: 0
Auto Clear Workcoor
Whether to clear workpiece coordinate when machining, cutting frame or dry run
starts.
0: No
1: Yes
Default value: 0
Enable Breakpoint Check
Check breakpoint when machining starts. If breakpoint exists, a prompt box will pop
up.
Default value: No
Enable Handle
Whether to enable handle control.
Default value: Yes