上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
96 / 144
Y1Y2 Dynamic Tolerance
When Y1-axis and Y2-axis are moving, if the difference between the feedback value
and output value is greater than the value, alarm will occur.
Range: [10, 1000]ms
Default value: 3
Double Y Error Detect Cycle
Cycle for detecting double Y error.
If the value is too large, alarm will not occur in time and the machine tool will be
damaged.
Range: [10, 1000]ms
Default value: 100
5.2 Speed and Accuracy Parameters
This section introduces parameters of speed and accuracy under Speed and
Accuracy category, including the following:
• 2.0 Manual Speed
– 2.0.0 Jog Speed
– 2.0.1 Manual Acceleration
– 2.0.2 Manual Axial Jerk
• 2.1 Machining Speed
• 2.2 Machining Accuracy
5.2.1 Jog Speed
XY-axis Rapid Jogging Speed
Speed in rapid jog mode.
Range: [Jogging speed, Maximum value of maximum speeds between XY-
axes]mm/min
Default value: 18000
XY-axis Jogging Speed
Default speed in jog mode.
Parameter XY-axis Rapid Jogging Speed takes its value before returning to the
machine origin.
Range: [0.06, Rapid jogging speed]mm/min
Default value: 6000
To Next Page
Loading...
