上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
95 / 144
W-axis Lead Screw Compensation Mode
Mode used to compensate lead screw error.
0: no compensation
1: backlash compensation
2: screw error compensation
Screw Error Compensation Positioning Speed
Positioning speed of laser interferometer in screw error compensation wizard.
Range: [0.06, maximum value in X-axis and Y-axis maximum speed values]mm/min
Default value: 1800
5.1.11 Double Y Error Setting
Y1Y2 Feedback Pulse Same Direction
Whether directions of feedback pulses in Y1-axis and Y2-axis are the same.
Yes: same direction
No: opposite direction
Default value: No
Double Y Tolerance
Range of double Y encoder origin error.
Range: [0, 10000]mm
Default value: 5
Enable Double Y Error Detect
Whether to enable double Y error detection.
Yes: enable
No: disable
Default value: Yes
Y1Y2 Static Tolerance
When Y1-axis and Y2-axis are steady, if the difference between the feedback value
and output value is greater than the value, alarm will occur.
Range: (0,100)mm
Default value: 3
To Next Page
Loading...
