上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
113 / 144
6 Electrical Wiring Diagram
This section introduces the following information about hardware installation in
NcEditor V12 Laser Cutting CNC System:
• Mounting dimension
• Wiring diagram of terminal board
• Wiring diagram of laser device
• Wiring diagram of drive
6.1 Mounting Dimension
In this section, you can quickly know about the dimension of hardware, so as to
confirm the space is sufficient during installation.
Mounting dimension of Lambda 5E terminal board is as follows:
Mounting dimension of EX30A terminal board is as follows:
To Next Page
Loading...
