上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
4 / 144
• In velocity loop control mode
W-axis refers to the focus axis and B-axis refers to the rotation axis. To avoid being
confused with Y-axis in plane cutting configuration, Y-axis in tube cutting
configuration is U-axis.
When installing the follow-up amplifier, you need to ensure the outer metal part of
the amplifier surface is well installed on the machine tool because its coat is used to
shield all signals that interfere internal circuit. Mounting diagram is as follows:
To Next Page
Loading...
