上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
62 / 144
• Param interface
1. Axis coordinate display area
2. Manual control area
3. Follow-up control buttons
4. Alarm display bar
5. Waveform display area
6. Main parameters area
7. Parameters setting area
4.1.1 Axis Coordinate Display Area
It is used to show the following:
• Workpiece coordinates
• Machine coordinates
You can switch between workpiece coordinates and machine coordinates by
clicking WorkCoor/MachCoor.
To Next Page
Loading...
