上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
67 / 144
In this page, you can do the following:
– Pause the waveform change:
If you double click within the coordinate, at the top of Y-axis
coordinate will turn into .
– Set scale parameters:
If you right click within the coordinate, a scale parameter dialog box will
pop up:
• If Auto Set Scale is checked, the system will automatically set
scale parameters. At this time, you cannot manually modify the
parameters.
• If Auto Set Scale is unchecked, at the top of Y-axis
coordinate will disappear. At this time, you need to manually
modify the parameters.
To confirm the setting, click your mouse or press Enter.
4.1.5 Main Parameters Area
It is used to show parameters for monitoring, including:
• Real-time monitoring parameters (unchangeable):
– Follow Enable
Used to show the status of follow-up enabling.
After is clicked, follow-up enabling is opened and the value of this
parameter turns into Enabled.
To Next Page
Loading...
