上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
65 / 144
• : Stop
After the button is clicked, the system stops machining and enters idle status.
It is used to normally stop machining task during follow-up control.
• : Servo Calibration
It is exclusive for velocity loop control mode.
After the button is clicked, the system executes compensation and eliminate the
zero drift of a servo motor.
• : E-stop
After the button is clicked, the system stops emergently.
4.1.4 Waveform Display Area
It is used to switch among the following waveform pages by clicking button on
the upper right:
• Mark Data page
Used to show the corresponding relationship between capacitance and position
between the cutting head and the workpiece during calibrating capacitance.
X-axis coordinate shows the capacitance while Y-axis coordinate shows the
distance between the cutting head and the workpiece.
To Next Page
Loading...
