上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
63 / 144
4.1.2 Manual Control Area
It is used to move the machine tool manually.
It includes the following:
• Axis direction buttons
Used to move each axis towards positive or nagative direction.
• Feed mode button
Used to select one of the following feed mode by clicking the circular button:
– Jog mode
Including low-speed jog mode and high-speed jog mode.
If you click an axis direction button, the machine tool will move at
jog/rapid jog speed until you release the button.
If you click several axis direction buttons at the same time, the clicked
axes will move at the same time at jog/rapid jog speed until you release
the buttons.
– Step mode
If you click an axis direction button, the machine tool will move the
customized step size.
To Next Page
Loading...
