上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
23 / 144
• : Breakpoint resume
Used to resume machining from the exact interrupted position when the power
interruption or e-stop occurs and the workpiece origin is secured.
• : Simulation
Used to execute simulation to check the toolpath in real-time.
• : Dry run
Used to run the machine tool without turning on related ports of laser and
machining. There is no actual machining.
• : Cut frame
Used to confirm the machining range by running the system along the frame of
the toolpath file.
• : Leveling and centering
Used to adjust a tube to horizontal status and find the center line of certain face
of the tube.
• : Return to center
Used to move each axis to return to the center position of the tube. W-axis turns
to horizontal status and X-axis returns to the center line of the tube.
• : Jog
Used to switch between jog mode and step mode by clicking .
In step mode, the default customized step is 10mm. To customize the step size,
double click this button.
Control the machine tool to move along the toolpath towards positive/negative
direction with / .
To Next Page
Loading...
