Weiler E1250 - MAINTENANCE INTERVALS AND LUBRICATION

1
WEILER E1250
3-2
Maintenance
3
MAINTENANCE INTERVALS
The maintenance intervals outlined in the following maintenance section are based on normal operating conditions.
When operating under severe conditions, the maintenance intervals should be shortened
.
Interval -
Hours
Reference Identification
No. of
Points
Type of
Lube
Quantity Remarks
Engine
Crankcase and
Components
-
1 Engine Coolant
1
50/50 - Check level in Radiator
2
Idler Bearings On
Elevator,
Conveyor and
ReMix Hopper
19 HTG 2 shots Do not over grease. Bearing failure may occur.
3
Elevator and
Conveyor
Footshaft
Bearings
4 HTG 2 Shots Do not over grease. Bearing failure may occur.
4
Pump Drive
Gearbox
1 80-90 - Check oil level with Dipstick
5
Hydraulic Tank
1 ISO 68
- Check level in sight gauge.
6
Engine Oil
1 Check oil level with Dipstick
7
Engine Air
Cleaner
1-
-
Check & Clean or replace element as required
8
Pump Drive
Clutch Throw Out
Collar
1 HTG 2 Shots
9
Pump Drive
Operating Shaft
1 HTG 2 Shots
10
Caster Wheel and
Castor Pivot
6 HTG 2 Shots
11
Steering
Knuckles
4 HTG 2 Shots
12
Tie Rod Ends
4
HTG
2 Shots
E1250 LUBRICATION CHAR
T
Refer to Engine Operators Manual furnished in addition to this manual
for maintenance intervals and procedures.
10
12
Ti
e
R
o
dE
n
d
s
4
HTG
2Sh
o
t
s
13
Steering
Cylinders
2 HTG 2 Shots
14
Elevator Lift
Cylinder
4 HTG 2 Shots
15 Conveyor Pivot 2 HTG 4 Shots
16 Pivot Cylinders 4 HTG 2 Shots
17
Conveyor Lift
Cylinder
4 HTG 2 Shots
18 Elevator Pivot 2 HTG 2 Shots
19 Hydraulic Filters 7 ISO 68
-
Replace first 250 hours and 1000 hours
thereafter
20 Wheel Planetary
4 80/90
- Check level plug add as needed.
21 Hydraulic Tank 1 ISO 68
-
Loosen drain plug on bottom o
f
tank and drain
any accumulated water from tank, retighten
plug and refill tank to proper level
22
Engine Oil and
Filter
1 15W-40 26.5 Qts.
Drain and Refill Engine Oil and Change Engine
Oil Filter
23 Fuel Filters 1 - -
Drain and Refill Engine Oil and Change Engine
Oil Filter
1000 5 Hydraulic Tank 1 ISO 68
Approx.
110 Gal.
Drain, flush, clean strainer, refill. Install new
filter breather cap
20 Wheel Planetary
4 80/90
3.3 Qts.
Drain, flush, refill.
24
Pump Drive
Gearbox
1 80/90
A
pprox. 6
Qts.
Drain, flush, refill.
3000
1
Engine Coolant
1 50/50
10 Gal
Drain, flush, refill.
HTG - HIGH TEMP GREASE. LITHIUM EP GREASE, EP-2
80/90 - 80W-90 GEAR OIL (API GL-5 & MT-1)
ISO 68 - ANTIWEAR HYDRAULIC FLUID, ISO GRADE 68
/ / COO / ( S )
250
50