1
2-4
Operation
2
WEILER E1250
DRIVING THE MACHINE
WARNING: CLEAR AREA AROUND MACHINE BEFORE MOVING.
1. Follow Engine Starting Procedure
2. Check to make certain PROPEL lever is in the NEUTRAL
position. Place the propel motor high/ low switch (1) in LOW
range. Place the propel creep switch in LOW range (2).
3. Move elevator and conveyors to a position that will not cause
them to collide with any objects
4. Fully open engine throttle to governed engine speed and
release parking brake (3).
5. Use PROPEL lever (4) to move machine. Speed increases as
the lever is moved away from neutral in either the forward or
reverse direction. Pull knob up to move past the neutral stop.
Maximum propel lever speed is determined by the speed dial
(pot) (5). Turn clockwise to increase speed.
6. When driving the elevator the two-speed motor and creep
switches can be shifted on-the-fly.
CAUTION: Down shifts of the two-speed motor can be abrubt. Slow machine down using the propel lever or
the speed dial before down shifting the motor. Equipment damage or personal injury may result.
To Next Page
Loading...