20 Operation
EN
The message Auto switch-on ON appears for three
seconds. After the message, the VENTIlogic re-
verts to the patient menu. Auto switch-on is now ac-
tivated.
5. Exit the patient menu using the dial (move selection
bar to Back and press dial) or using the menu
switch .
If no switch is activated for 5 minutes, the display
reverts to the standard display.
Deactivate auto switch-on
Repeat steps 2.–5. as described in „ Activate auto switch-on“. When the automatic
system is switched off, you can only switch on the VENTIlogic using the switch.
5.3 Set soft start (not in TA mode)
If your doctor has enabled the soft start function, the soft start time can be selected
in 5-minute increments up to a maximum time of 30 minutes. Your doctor can limit
the maximum time to less than 30 minutes. Proceed as follows to set soft start time.
1. Seal the hose system or put on the mask.
2. Switch on the VENTIlogic and hold down the soft
start switch until the soft start window ap-
pears. Change the soft start time using the dial
(turn to the right to increase time and turn to the left
to decrease time). Alternatively, keep pressing the
soft start switch to increase the soft start time
in 5-minute increments (once maximum time is
reached, the unit restarts at the minimum time of 5
minutes if pressed again).
3. Press the menu switch or the dial to store the soft start time. The soft start time
displayed will be stored and the soft start window closes automatically. If no
switch is pressed for 4 seconds, the soft start time displayed is likewise stored.
The settings are retained after the unit is switched off.
To Next Page
Loading...
Need help?
General
