Hygienic preparation 27
EN
4. Let the coarse dust filter dry. The coarse dust filter must be completely dry before
the unit is started up.
5. Replace the coarse dust filter and close the filter compartment cover.
Note:
the fine filter cannot be cleaned. It is changed every 1000 operating hours.
Accessories
To clean the exhalation system, the mask, the headgear/headband, the
VENTIpower, the VENTI-O
2
, the bacteria filter and the VENTIclick, please see the
section entitled "Cleaning" in the relevant operating instructions.
6.3 Disinfection, sterilization
If necessary, for example after an infectious illness or if the unit has become unusually
soiled, you can also disinfect the housing, the connecting cord, the hose system, the
bacteria filter housing, the VENTIclick, the VENTI-O
2
and the VENTIpower. Refer to
the operating instructions for the disinfectant used. We recommend that you wear
suitable gloves (e.g. household or disposable gloves) when disinfecting the equip-
ment.
Unit
The housing and the connecting cord of the VENTIlogic are cleaned by simply being
wiped over with disinfectant. We recommend TERRALIN
®
for this purpose.
Hose system
We recommend GIGASEPT FF as disinfectant. When using GIGASEPT FF, use the
same procedure as described under "Cleaning".
After disinfecting, rinse all parts thoroughly in distilled water. Let the parts dry com-
pletely.
Let the hose system drip. Dry the hose system using the VENTIlogic as described in
6.2.
• Creased hose WM 24130 (clear) can be cleaned using hot water
up to 70 ˚C. Sterilization is not permitted.
To Next Page
Loading...
Need help?
General
