Operation 21
EN
Note
• VENTIlogic starts in soft start mode automatically if this was activat-
ed when the unit was last used.
• Soft start can be switched on and off at any time by briefly pressing
the soft start switch .
• The Softstart function is not available in TA mode.
5.4 Set humidifier
The VENTIclick humidifier can be used to humidify and heat up the respiratory air
supplied by the VENTIlogic. Heat output can be selected in six stages. Proceed as
follows.
1. Seal the hose system or put on the mask.
2. Switch on the VENTIlogic and press the humidifier
switch until the Humidifier stage window ap-
pears. Alter the heat output (stages 1-6) of the hu-
midifier using the dial or repeatedly press the
switch.
3. Press the menu switch or the dial to store heating output. The Humidifier stage
window closes automatically. If no switch is pressed for 4 seconds, the heating
output displayed is likewise stored. The settings are retained after the unit is
switched off.
Please also see the operating instructions for the VENTIclick.
Note
• VENTIlogic automatically starts with the VENTIclick activated if this
was activated when the unit was last used. VENTIclick can be
switched on and off at any time by briefly pressing the Humidifier
switch . When the humidifier is activated, the green status indi-
cator next to the humidifier switch is illuminated.
• If you press the humidifier switch without a humidifier being con-
nected, the VENTIlogic switches this function off again automatically.
To Next Page
Loading...
Need help?
General
